KoolAir magnetic driven pumps.

KoolAir presents two of the powerful magnetic driven pumps specially made for boat, yacht and ships. 

1- KoolAir PM 500-115 Magnetic Driven Pump.
2- KoolAir PM 500-230 Magnetic Driven Pump.

Specifications 

Max Flow - 8.5 GPM 31 LPM
Max Head -19 FT 4.3 M
Power - .05 HP .037 KW
Electrical - 230V 50/60 HZ
Submersible - Yes
Inlet - 3/4″ FPT
Outlet - 1/2″ MPT

Wet End - Polypropylene (Front and Rear Housing, Impeller), Cooling Tube, Buna N (O-Ring, Cooling Tube Seal), Ceramic (Shaft, Thrust Washer), Ceramic Magnet
Uses - Submersible or Open Air

When submerged, the following is also in contact with the solution:  Epoxy, Stainless Steel, Polysulfone, Cord.

Why to use KoolAir Pumps

The KoolAir PM 500-115 and PM 500-230 Magnetic Drive Pump is most commonly used for marine air conditioning and fountains.

The ETL Listed Mark indicates to distributors, retailers and customers that your product has been tested by Intertek and found in compliance with accepted national standards.

Koolair PM 500-115 and PM 500-230 Magnetic Drive Pump 3/4″ FPT Inlet 1/2″ MPT Outlet, 8.5 GPM @ 19 Feet of Head (31 LPM @4.3M). Includes original base and the  fully integrated  marine base. Completely submersible, with run dry protection (10 lbs.), .05 HP (.037 KW) 115 volt 50/60HZ.

The Koolair PM500-115 and PM 500-230 is a completely submersible seal-less centrifugal magnetic pump drive (10 lbs.) generating a maximum flow of 8.5 gallons per minute with a maximum head of 19 feet at 8.2 PSI. The pump is dry run protected to withstand thermal overloads without failure. When cooled, the pump will resume operating normally.

Materials exposed to the solution (wet end) are Reinforced Polypropylene, Buna N and Ceramic Magnet. When submerged, Epoxy, Stainless Steel, Polysulfone, and the Cord will also come in contact with the solution.

The inlet connection is a ¾” female pipe thread and the outlet is ½” male pipe thread.

Includes fully integrated, heavy duty marine base, as well as the original base.

The motor is a 1 Phase 115V, .05 Horsepower motor, running on either 50 or 60 HZ

Maximum internal pressure is 25 PSI and the maximum liquid temperature is 130 Fahrenheit or 54 Celsius.

Titan Marine Air (Blogs)

Visit us at : www.titanmarineair.com 

Contact us at -

St. Maarten 

Email: info@titanmarineair.com  Tel: 1 (721) 550-2853

South Florida

Email: info@titanmarineair.com  Tel: 1 (954) 406-3015